Hardware Setup
15
Power Failure Recovery Jumper (JP3)
Computers using an ATX power supply usually do not
turn back on after the power source to the computer
unexpectedly fails (i.e. electricity outage). Setting the cap
at location 2~3 will allow the computer to always turn back
on after a power failure. This is especially important for
computers that must be on 24 hours per day.
Clear CMOS Data Jumper (JP2)
To clear the contents of the CMOS, please follow the
steps below.
1. Disconnect the system power supply from the power
source.
2. Set the jumper cap at location 2~3 for 5 seconds, then
set back to the default position.
3. Connect the system's power and then start the system.
4. Enter BIOS, load the setup default settings in the
CMOS Setup Utility Menu and then set the system
configuration in the Standard CMOS Setup menu.
Dual Channel USB(Universal Serial Bus) Connector (J14)
USB is an open industry standard, providing a simple and
inexpensive way to connect up to 125 devices to a single
computer port. Keyboards, mice, tablets, digitizers,
scanners, bar-code readers, modems, printers and many
more can all be used at the same time.
USB is a dynamically reconfigurable serial bus with an
elementary data rate of 12Mbps, based on off the shelf,
low cost micro-controller technology. It's modular layered
software protocol supports sophisticated devices and
application programs.
1
1
No recovery
Recovery
1
1
Default
Clear CMOS Data
