Chacon 34272, Руководство пользователя

Страница: 4 / 40

Wall mounting:
3. Operating instructions
4. Detector installation
5. Adjusting the brightness
There are two possibilities, either wall mounting or simply placing it on your furniture using the
integrated support foot.
To change your lighting, simply press the power/brightness button once (see diagram). You can
choose between 3 lighting levels.
Note: The CO2 concentration is 550ppm at start-up, please wait 30s for self-calibration
before using.
Note: When your device is plugged in, the temperature level is higher than normal.
BUTTONS
ON MODE OFF MODE
LONG PRESS SHORT PRESS LONG PRESS SHORT PRESS
At least 1.5sec. for
switching off
Brightness
adjustment
At least 1.6sec.
to switch on
No operation
At least 1.5sec. to
decrease volume
Mute or unmute
the alarm
No operation No operation
1. Using a pencil and the magnetic wall plate, mark the drilling
points for better accuracy.
2. Add the dowels to the holes.
3. Place the mounting plate and tighten with the screws.
4. Place the Co2 sensor on the plate. The plate will stick magneti-
cally due to the built-in magnets.