-3-
-4-
Precautions
It is recommended to use the 9-minute mode every time you drink for
optimal hydrogen concentration. If you have less time, the 3-minute
mode is also very beneficial.
If the unit has been empty and the electrode plate has dried out, pour
30 ml (2 tbsp) of white vinegar into the cup and producing hydrogen
using the 9-minute mode setting. This will remove any bacteria and
calcium buildup. Perform a final rinse and the unit is ready for use.
Please reserve a small amount of water in the cup at all times to keep
the membrane wet to generate maximum hydrogen with each use.
Please do not operate dry. To avoid burning out the membrane, only
use with water in the bottle.
If the red light appears during hydrogen production process, please fully
recharge before continuing use.
To avoid damage never use detergent on device. To clean use only
white vinegar.
Water temperature should not exceed 60 °C/140°F. Never use boiling
water with this device.
Clean gently to avoid scratching the electrode or damaging the
platinum coating on the hydrogen generator. Use only a soft cloth and
never hard or abrasive objects.
Please do not put any of the components into the microwave.
Please do not submerge the unit completely in water.
Do not disassemble, repair, or modify the product in any way.
Purpose #2. Portable Use with Water Bottle (as shown in Figure 5)
1. Separate the cap and base from the provided cup (as shown in
Figure 1).
2. For portability, screw the cap directly to the base (as shown in Figure
2). Unscrew cap and base when ready to hydrogen production with
water bottle.
3. Open your bottle and pour out a bit of water so the water line is
about 1.5 cm (2/3 inch) below the bottleneck. After creating space at
the top of the bottle, squeeze the water to the very top before screwing
on the base. This removes excess air and gives the hydrogen space to
generate.
4. Screw the base tightly onto the water bottle, making sure there are
no leaks. Turn the bottle over so base sits at the bottom.
5. Select hydrogen production mode and drink when complete. Total
generation time should not exceed 9 minutes to avoid the accumula-
tion of pressure inside the water bottle.
Purpose #3. Use with Hydrogen Inhalation Lid (as shown in
Figure 6)
1. Take out the hydrogen inhalation cap and tube. Take off the water
cap from the bottle.
2. Pour drinking water (purified water, filtered water, mineral water)
into the water bottle to the half position of the bottle. Then tighten the
hydrogen inhalation lid (accessories).
3. Insert the "bell mouth" of the nasal cannula onto the hydrogen
inhalation lid, and wear the other end on the nose.
4. Touch the switch two or three times continuously, and start the
hydrogen inhalation mode for three minutes or nine minutes. It can
operate repeatedly for multiple times of inhaling hydrogen.
1.5cm
Use with Hydrogen Inhalation Lid
1
2
3/4
1. Pour out a
bit of water
3. Put upside
down
4. Turn on the
base
5. Drink the
water
2. Squeeze the
water to the very
top and screw the
bottle on base
