ASSEMBLY (CONTINUED)
ATTACH DRIVE BELT TENSION HANDWHEEL
Refer to figure 8.
1. Place handwheel assembly onto shaft.
2. Secure in position with set screw.
STABILIZE MACHINE
To ensure sufficient upright stability of the machine it should be
bolted to floor, bench or worktable. For this purpose 8mm holes are
provided in the machine’s base. Mounting hardware not provided.
USE SUITABLE DUST COLLECTOR
The band saw has a 4" dust port included (See Figure 8).
It is recommended that when in use, the band saw is connected to
a suitable dust collector.
INSTALLATION
WARNING:
All electrical connections must be performed by a
qualified electrician.
ELECTRICAL CONNECTIONS
WARNING:
Make sure unit is off and disconnected from power
source any time wiring is inspected.
POWER SOURCE
Band Saw is prewired for 120 volt, 60 HZ power source.
The motor is designed for operation on the voltage and frequency
specified. Normal loads will be handled safely on voltages not more
than 10% above or below the specified voltage.
Running the unit on voltages which are not within the range may
cause overheating and motor burn-out. Heavy loads require that
the voltage at motor terminals be no less than the voltage speci-
fied. Power supply to the motor is controlled by a single pole toggle
switch.
GROUNDING INSTRUCTIONS
WARNING:
Improper connection of equipment grounding
conductor can result in the risk of electrical shock. Equipment
should be grounded while in use to protect operator from
electrical shock.
• Check with a qualified electrician if grounding instructions are
not understood or if in doubt as to whether the tool is properly
grounded.
5
NORSE Operating Manual & Parts List 9683125
Figure 8 - Attach drive belt tension handwheel.
Drive Belt Ten-
sion Hand-
wheel
Dust Port
Figure 10 - Know your band saw.
Blade Tension
Quick Release
Lever
Tracking
Knob and
Lock Nut
Blade Guide
Blade Guide
Height Adjust-
ment Knob
and Lock
Figure 11 - Know your band saw.
Table Tilt
Adjustment
Knob
Dust Port
Table Tilt
Lock Handle
Motor
Figure 9 - Know your band saw.
Blade Tension Knob
Door Locking Knob
Miter Gauge
Door Locking Knob
Rip Fence
ON/OFF
Switch
Guide Rail
Drive Belt
Tension Knob
