ASSEMBLY (CONTINUED)
3. Attach the two braces (Ref. No. 2) to the top front and bottom
front of the side panels using four hex head bolts and flat wash-
ers.
4. Attach the shelf (Ref. No. 4) to the center of the side panels
using four hex head bolts and flat washers.
5. Attach the door assembly (Ref. No. 7) to the left panel using two
pan head screws and flat washers (Ref. Nos. 8 and 9).
6. Secure all hardware.
7. Place band saw on top of stand and secure in position using
four flat head screws, washers and hex nuts (Ref. Nos. 12, 10 and
13).
ATTACH TABLE TO TRUNNION
Place the table on the trunnion, taking care when passing the saw
blade through the slot of the table. (See Figure 3).
1. Locate four M6 x 16 hex bolts and four M6 flat washers from the
bag of loose parts.
2. Mount the table to the upper table trunnion and install a bolt
with washer in each hole, and then tighten with adjustable
wrench.
CENTERING THE TABLE
1. Loosen the hex bolts mounting the trunnion to the saw frame
(See Figure 3).
2. Move the table sideways as required, until the saw blade runs
through the center of the table insert.
3. Re-tighten hex bolts for trunnion and recheck the saw blade
position.
SETTING TABLE SQUARE TO SAW BLADE
Loosen the knob on the lower table trunnion and place a suitably
sized square against the saw blade. If the table requires adjustment,
proceed as follows:
1. Using a wrench, release the hex nut on the bolt (see Figure 4).
Place the wrench on the hex bolt and adjust until the table is
square to the saw blade.
2. Tighten the hex nut and recheck the saw blade and the table
for squareness.
3. Lock the table into position and check that the indicator reads
zero degree on the side of lower table trunnion. Loosen the
screw securing the indicator and reset if necessary to give zero
degree reading (see Figure 3).
ATTACH GUIDE RAIL
Refer to Figure 5.
• Fasten the guide rail with four each wing nut bolts and washers
to the table.
INSTALL RIP FENCE
• Lay the rip fence onto the guide rail. Adjust the rip fence paral-
lel to the saw blade. Tighten rip fence handle by pressing down-
ward (See Figure 6).
ATTACH PUSHSTICK STORAGE HOOK
Refer to Figure 7.
1. Thread hex nut completely up to unthreaded portion of hook.
2. Thread hook into saw frame several turns.
3. Tighten hex nut against saw frame.
• Store pushstick on hook when not in use.
Figure 4 - Square table to saw blade.
Square
Hex Nut
Hex Bolt
4
NORSE Operating Manual & Parts List 9683125
Figure 3 - Attaching and centering table.
Bolts to
attach table.
Indicator
Adjust-
ing Bolts
Figure 5 - Attach guide rail.
Wing Knob Screws
Figure 6 - Attach rip fence.
Fence
Figure 7 - Attach pushstick hook with nut.
Hook
with
nut.
Pushstick
