Page: 19/81 User Manual PSU-CTRL-2D, Rev.1-00: Software Utilities
Tab. 2. Command line parameters of the program
COM-HVPSU2D-
Control
- General control.
Parameter Explanation
-b, -B
get the device buffer status
(see function
)
-z, -Z
purge the communication
(see function
)
-t, -T
terminate the program
-q, -Q
quiet mode
-g
debug mode
-G
debug mode with output into
Debug.txt
-$
speed
set the communication speed to the value
speed
(see function
)
-!
restart the device
(see function
)
-?
show the help text with the list of all available com-
mands
the continuous mode, an operation is repeated until the user interrupts
it by pressing a certain key - usually Esc.
Numerical integer values can be specified either in decimal code or in
hexadecimal or binary ones when characters
h
or
b
are appended.
This implies that, for example,
16
,
10h
or
10000b
all specify the
same value, namely sixteen.
If you wish to specify a name parameter containing spaces or special
characters, such as a pathname of a file containing spaces, use the
conventions valid for your operating system. In Windows™ systems,
for instance, enclose the names in quotation marks.
General Control
The command line parameters for the general control are listed in
Tab. 2. They are intended to control the function of the utility.
The communication speed defaults to 9600 baud (see section
"Software Interface"). This is usually sufficient for any short data trans-
CGC Instruments
Tel.: +49 (371) 355 098–55
Hübschmannstr. 18 | D–09112 Chemnitz
Fax: +49 (371) 355 098–60
internet: www.cgc-instruments.com
e–mail: [email protected]
