CGC Lawnaire IV, Техническое руководство

Страница: 12 / 32

10
Lawnaire
IV
OPERATION
AERATING
NOTE : For best performance and maximum tine
penetration, the lawn should be thoroughly
watered the day before aeration.
1. Rotate the water drum on the front of the unit
until the filler plug F is positioned at the top.
Remove the plug, fill the drum with water and
replace the plug.
2. Place weights B in large tube portion of the frame
(if not already installed) and secure in place on
each end with weight latches A .
3. Move the engine On/Off switch to the "ON"
position and then pull the recoil starter and choke
as required to start the engine.
NOTE: Fuel shutoff valve should be open.
4. Lift the transport lift handle if necessary to make
sure the tines are not touching the ground,
advance the throttle, slowly pull back on the
clutch handle control and transport the aerator to
the work area.
NOTE : Never cross hard objects or surfaces (such
as sidewalks, driveways, stepping stones, etc.) with
tines in the down position.
5. Upon reaching the work area, release the clutch control handle and adjust the throttle speed for aerating.
6. Push down on the transport lift handle, lowering the aerating tines to the turf.
7. Pull back slowly on the clutch control handle to start aerating.
NOTE : For maximum tine penetration into turf, apply downward pressure on the handle, until drum is off the
ground.
8. At the end of each aerating pass, release the clutch control handle, lift up on the handle assembly and
pivot the unit on the water drum. Resume aerating.
NOTE: For reverse, pull back on the handlebars when in the transport position.
9. When finished aerating, lift up on the transport lift handle to move the unit into transport position.
10. Drain the water drum when finished with aerating.