CGC Lawnaire IV, Техническое руководство, Страница: 11 / 32

9
Lawnaire
IV
OPERATION
PRE-OPERATION CHECK
1. Visually check all moving parts and all fasteners.
If loose or broken, tighten or replace. Check
handle locking knobs and hand tighten if
necessary. Check for broken or bent tines;
replace if necessary
2. Check the engine crankcase and gear reduction
case oil levels with the engine resting in a level
position. Add oil if necessary.
3. Follow the engine manufacturer's
recommendations for the correct type and
amount of oil. Fill the fuel tank according to the
engine manufacturer's specifications.
Gasoline is extremely flammable and highly
explosive under certain conditions. Always stop
the engine and do not smoke or allow open
flames or sparks when refueling. BE SURE to
install fuel cap after refueling.
NEVER start or run the engine inside where
exhaust fumes can collect. Carbon monoxide
present in the exhaust is an odorless and deadly
gas.
DO NOT operate equipment without shields in
place. DO NOT make adjustments or perform
any maintenance while the engine is running.
Before operating, check the area and remove
any object which may present a safety hazard or
damage the equipment.
This unit is not designed to be used on steep
slopes. To prevent injury and/or damage to
equipment, use extreme caution when operating
near terraces or hilly terrain. Travel up and down
slopes at a 45 degree angle rather than across,
to prevent unit from tipping over, DO NOT
release clutch handle on a slope; this will cause
freewheeling, allowing the unit to roll down the
slope.