PAS Specifications :
Drivers (satellites) One 2 inch full-range per satellite
One 2.5 inch passive radiator
Drivers (subwoofer) One 4.5 inch long throw woofer and
one 5.25 inch passive radiator
Satellite Freq. Resp 100 Hz - 18 kHz @ -10dB
150 Hz - 17 kHz @ -3 dB
Subwoofer Freq. Resp 47 Hz - 400 Hz @ -10dB
60 Hz - 200 Hz @ -3 dB
Satellite Power 9 w RMS per channel at < 10 %THD
7 w RMS per channel at < 1 % THD
Subwoofer power 20 w RMS per channel at < 10 % THD
15 w RMS per channel at < 1 % THD
Input Impedance 20K Ohms
Signal-to-Noise Ratio > 93 dB
Crossover Frequencies:
Subwoofer 200 Hz Linkwitz-Riley
Satellites with subwoofer 200 Hz
Satellites without subwoofer
100
Hz
PAS Power Requirements:
Switching power supply 100 - 240 Volts Universal / 50 - 60 Hz AC
MAX Power Consumption 40 watts
UL, cUL, CE, CB Approved
CVS Specifications :
Dimensions for Transmitter and Receiver:
104 mm long, 62 mm wide,
24 mm high
Total System Weight with batteries:
232 grams, 8.2 ounces
Power Source:
One 9 volt Alkaline battery in each Transmitter and
Receiver.
Battery Life:
6 to 8 hours
Microphone:
Uni Directional Electret Condenser, tie clip mount, 1 meter
shielded wire.
Frequency Response:
80 hertz to 10 kilo hertz
Dynamic Range:
better than 80 decibel
Signal to Noise Ratio:
better than 80 decibel
Transmitter RF Output:
30 mW (50 mW maximum)
Working Range:
Up to 250 feet
Crystal Controlled Operating Frequency:
Selectable:
Std F1 = 169.445 MHz, F2 = 170.245 MHz
TVHF F1 = 179.400 MHz, F2 = 180.600 MHz
Receiver Type:
Double Superheterodyne
Reception Sensitivity:
2 uV for 40 decibel Signal to Noise
Reception Selectivity:
+/- 15 kilo hertz
Image Rejection:
Better than 30 decibel
Maximum Line Level Output:
2.8 volts RMS into 2000 ohms, 2.1 volts
RMS into 32 ohms at 1%THD; 3.5 mm stereo jack
Maximum Microphone Level Output:
71 mV RMS into 2000 ohms at
1% THD; 3.5 mm mono jack
FCC ID: N7GCVT-1 CANADA: 3233231133
Page 23
Specifications and Power Requirements