CESYG DUALFO, Инструкция по установке и эксплуатации, Страница: 14 / 32

the frame and fit the four M3 screws supplied to hold the DUALFO in place. Tighten
the screws, but do not over tighten them. The recommended torque is 1.0Nm.
Note
: if your rack rails are made to accept M2.5 screws you must either supply them
yourself, or they were provided with your DUALFO as a special option, or you can
purchase them either from CESYG or elsewhere.
Power-on Test
Refit the AC power cable to your synthesizer. Set the DUALFO Freq controls to
maximum, set the CV controls to minimum, and the Shape control to midway; the
Sync button can be in or out.
Turn on power.
Both oscillator LEDs should be flashing red/green - they should be visibly flickering.
This concludes the installation.
CESYG DUALFO USER MANUAL
Page 14