CESYG DUALFO, Инструкция по установке и эксплуатации, Страница: 11 / 32

3. INSTALLATION
Fitting the DUALFO into your modular synthesizer is a straightforward task. This
section describes the basic steps in unpacking and installing your DUALFO and a first
initial power-on test.
Unpacking
The DUALFO comes packed in anti-static packaging. Do not open the packaging until
you are ready to install the module in your modular synthesizer. As well as the
DUALFO you should find this manual, a 16-way power cable, and a bag of M3x6mm
screws.
Make sure you have a space of at least 18HP (91mm) in your rack unit, and one spare
power connection.
Installing the Power Cable
The DUALFO is fitted with a standard 16-pin power header and supplied with a power
cable. If your power distributor is 10-way then will need a special 10/16-way adaptor
cable. These are available from many sources online.
Disconnect power from your synthesizer. It is recommended to remove the AC power
cable from the wall socket. Fit one end of the module power cable to the DC distribu-
tion board in your synthesizer. Leave the other end trailing out of the case.
CESYG DUALFO USER MANUAL
Page 11