CES M-20 Repeater Maker plus, Инструкция по установке и эксплуатации

Страница: 14 / 22

CES SUPPORT 407-679-9440 Page 14 MAN79 © CES 2009
3.2 Programming Table Summary
Code Function Range Default value
00 # Exit program mode n/a n/a
1 # COR Source 0 or 1 0 (discriminator)
2 # External COR polarity 0 or 1 0 (active low)
3 # Roger beep 0 ~ 2 1 (enabled)
4 # CTCSS TX (tone 1) 0 ~ 50 0 (disabled)
5 # CTCSS RX (tone 1) 0 ~ 50 0 (disabled)
6 # CTCSS TX (tone 2) 0 ~ 50 0 (disabled)
7 # CTCSS RX (tone 2) 0 ~ 50 0 (disabled)
8 # CTCSS TX (tone 3) 0 ~ 50 0 (disabled)
9 # CTCSS RX (tone 3) 0 ~ 50 0 (disabled)
10 # CTCSS TX (tone 4) 0 ~ 50 0 (disabled)
11 # CTCSS RX (tone 4) 0 ~ 50 0 (disabled)
12 # CTCSS tone during hangtime 0 or 1 0 (disabled)
13 # CTCSS tone 1 0 or 1 0 (disabled)
14 # Repeater hangtime 0 ~ 9 2 (2 seconds)
15 # Interconnect PTT input 0 or 1 0 (disabled)
16 # Interconnect PTT input polarity 0 or 1 0 (active low)
17 # Interconnect mode input 0 or 1 0 (active low)
18 # Interconnect output polarity 0 or 1 0 (active low)
19 # Interconnect active period 0 ~ 60 3 (3 seconds)
20 # Interconnect repeat 0 ~ 2 1 (enabled)
21 # Morse code ID send 0 ~ 3 0 (disabled)
22 # Morse code ID interval timer 0 ~ 90 3 (3 minutes)
23 # TX time out timer 0 ~ 90 2 (2 minutes)
24 # TX time out penalty 0 ~ 30 0 (disabled)
25 # TX disable input 0 or 1 0 (disabled)
26 # TX disable input polarity 0 or 1 0 (active low)
27 # COR Only produces CTCSS 0 ~ 4 0 (disabled)
28 # Auxiliary relay code 8 digits max. (null)
29 # Morse code ID (call letters) 9 digits max. (null)
30 # Over the air programming code 9 digits max. (null)
99 # Program factory default n/a n/a
Table 4 Programming Summary
Programming Parameters Explained
The following is a list of available programmable features. Parameters in bold letters denotes factory defaults .
(00# will exit the program mode).
COR Source (1#) (Means in which the RM-20 determines receiver activity)
The model RM-20 can be programmed for internal or external COR. Internal COR which is the factory default
requires that the RX Audio input be connected to the discriminator of the receiver. (See RX Audio description)
Otherwise, the External COR input must be used and this item programmed to “External COR” To program this
item enter the command code followed by a 1 or 0, (don’t forget to enter a # (pound ) key between commands and at
the end of the entry sequence).
1#0# = internal 1#1# = external