System Manual
2018 Cervis, Inc.
17
1
3
2
4.0 Warrior MU-X15 System Operation
4.1 System Startup
The following assumes that power is applied to the Warrior
MU-9X15 receiver.
1. Press the handheld STOP button (B1).
2. Wait while the LEDs cycle and then the RX/TX begins to
flash.
3. Press the Horn/Start button (B2). This energizes the
MLC relays in the receiver.
The handheld is ready for normal functional operation.
4.2 Associating a Handheld with a Receiver
Warrior MU-X15 system handhelds are associated to the receiver before the system is shipped
and the Association process is locked by DIP switch 8 in the receiver being 0 (OFF). The
receiver will only communicate with handhelds it is associated with. When necessary, other
Warrior handhelds can be associated to the receiver as additional spares or to replace damaged
handhelds but the receiver’s association ability must be unlocked first.
There are two methods to unlock association:
First
is by manually changing the position of DIP switch 8 in the receiver. To unlock
Association, DIP Switch 8 must be changed from its default position (0 (OFF)) to (1 (ON)).
Unlocking with the DIP switch will unlock association until DIP switch 8 changed back to the
0 (OFF) or LOCKED position.
Second
is by using an already associated handheld and preforming a “virtual” UNLOCK.
This process allows users to unlock the receiver from a distance without needing to access
the receiver. A virtual unlock will allow the user to associate with the locked receiver for a
limited time; after five minutes or after a successful handheld association the virtual unlock
will expire and the receiver will become locked again.
4.2.1 Associating a Handheld Using the DIP Switch Unlock Option.
This process will unlock association of the receiver allowing the user to associate handhelds to
the receiver until the DIP switch is set back to the locked position.
1. Set the receiver SW01 DIP Switch 8 ON (UP).
2. If the receiver is
Off
, the Horn/Light relay will activate when it is powered. If the receiver
is
On
, the Horn/Light relay will immediately activate.
3. Go to section 4.3
It is not recommended to leave receivers in an UNLOCKED
state. Move DIP switch 8 to the “0” (OFF) position once
association is complete.
Caution!
