Warrior CB-9X Console Box Transmitters
U103.1.0
14
2.7
Clearing CB-9X Stored Receiver ID (Factory Reset)
The CB-9X transmitter stores the associated receiver ID. It may become necessary during
instances of severe interference
—or perhaps when troubleshooting—to break the established
communications link between the console box transmitter and the system receiver. This is called
“clearing the ID” or “Factory Reset.” Use the following steps to clear the ID.
Clear the Stored Receiver ID (Factory Reset)
1. With the console box OFF, turn the keyswitch
S18
to the
ON
position.
2. Momentarily press the Horn/Start
pushbutton (
S12
) to wake the transmitter.
Note: Perform the next step within two seconds. Otherwise, you must restart the
process.
3. Cycle (transition from
OFF
to
ON
) the
Stop Switch
.
4. LED
B
will illuminate for about 1.5 seconds after cycling the stop switch. While
this LED is on, enter
Maintenance Mode
by simultaneously moving and holding
switches
S13
and
S14
down until the LEDs cycle from bottom to top, indicating
that the CB is in maintenance
mode.
5. While in maintenance
mode, simultaneously hold switches
S13
and
S14
Down
.
Press the
Stop Switch
while holding the switches down.
Notes:
When a transmitter is not associated with a receiver, the transmitter lights all the LEDs and
then powers down shortly after being turned on.
The receiver does not need to be on when clearing an ID from the transmitter.