2019
Cervis, Inc.
11
2.5
Turn CB-9X Transmitter Off
Shut down the console box transmitter via any of the following methods:
Push the
STOP
button down for immediate stop.
Do not activate any switch and wait for the console box Switch Inactivity Timeout to expire
(standard is four minutes).
Turn the keyswitch (
S18
) to the OFF position.
2.6
Associate CB-9X with the System Receiver
The CB-9X system transmitter must be associated (communications link established) with a
system receiver before the system can be used. The CB-9X stores the target receiver ID
following successful association with a chosen receiver. Systems are associated at Cervis, Inc.
before leaving the factory; but there may be times when it is necessary to associate while in the
field.
Use the associate process described in the following steps to associate a receiver with the CB-
9X transmitter when needed.
Associate with Receiver (Figure 4)
1. With the Console Box OFF, turn the keyswitch (
S18
) to the
ON
position.
2. Press the Horn/Start pushbutton (switch
S12
) to wake the transmitter.
3. Within 2 seconds after pushing the pushbutton, cycle the
STOP Switch
(transition from
OFF
to
ON
).
4. The
B
LED lights for about 1.5 seconds after cycling the
STOP Switch
. While
this LED is active (ON), enter
Maintenance Mode
by simultaneously moving
switches
S13 and S14
DOWN
for approximately one second.
Note: Restart the process if you wait too long to perform this operation.
The LEDs cycle from bottom to top, indicating that the console box is in
Maintenance
Mode.
5. Simultaneously lift and hold switches
S13 and S14
UP
for five seconds to enter
Association Mode
. Release both switches when LED
A
starts to blink.
6. While in Association Mode, the
B
and
RF
LEDs light solid, indicating that the
console box is attempting to locate any available receivers it can
Link
to.
