Cervis Warrior 32 HH2S-9XL10, Руководство пользователя

Страница: 8 / 15

U101.1.0 2
1.1
HH2S-9XL10 Battery Installation
HH2S-9XL10 handheld units are powered by two AAA alkaline batteries. When installing
batteries, be sure to observe proper polarity as marked on the inside of the compartment to
avoid damaging the unit. To replace or install batteries in the handheld:
1. Loosen the four small Phillips screws from the Battery Compartment cover and
lift the cover from the handheld. The screws remain attached to the cover.
2. If installing batteries in an empty battery compartment, install two fresh size AAA
alkaline batteries. Be sure to position the batteries as shown in Figure 4.
3. If replacing expired batteries, remove the old batteries and install two fresh size
AAA batteries. (Discard the used batteries in accordance to local regulations.) Be
sure to position the batteries as shown in Figure 4.
4. Replace the compartment cover and tighten the four Phillips screws. These
screws should not be over-tightened, but they should be tight enough to ensure
the gasket provides a proper seal.

Note: Discard expired batteries in accordance with local regulations.
Figure 4. HH2S-9XL10 Battery Installation
Be sure to observe proper polarity when placing batteries in
the handheld battery compartment.
Sealing gasket
Cover
screws