Handheld Remotes Manual
2013 Cervis, Inc.
7
4.0 Battery Installation or Change
SmaRT HH-xH06 handheld units are powered by three size AAA alkaline batteries. When
installing batteries, be sure to observe proper polarity as marked on the inside of the
compartment to avoid damaging the unit. To replace or install batteries in the handheld:
1. Remove the four small Phillips screws from the Battery Compartment cover and
lift the cover from the handheld.
2. If installing batteries in an empty battery compartment, install three fresh size
AAA batteries. Be sure to position the batteries as shown in Figure 4 below.
3. If replacing expired batteries, remove the old batteries and install three fresh size
AAA batteries. Be sure to position the batteries as shown in Figure 4 below.
4. Replace the compartment cover and tighten the four Phillips screws. These
screws should not be over-tightened, but they should be tight enough to assure
the gasket provides a proper seal.
Figure 4. Handheld Battery Installation
Note: Cover screws must be tightened enough to ensure the sealing gasket is compressed.
Do not over-tighten the screws.
Be sure to observe proper polarity when placing batteries in the
handheld battery compartment.
Sealing gasket
Cover
screw
