C400R User Manual
Page 14
Take off the front panel. To do this remove the 2 screws from the right-hand side of the front of the UPS, carefully take out the LCD
screen and remove the screw behind it.
Finally, push inward the small blanking plate on the side of the front panel in order to remove it. This then enables you to connect
the battery terminal (A) from the UPS to the EBM terminal (B) shown below. After doing this reassemble the front panel.
STEP FIVE
If 1 or fewer EBMs are to be connected skip to step six
To install multiple EBMs connect an Earth line between the UPS and the first EBM and then connect a second Earth line between
the first EBM and the second EBM
Take off the front panel as instructed in the previous steps,
This then enables you to connect the battery terminal (A) from the UPS
to the EBM terminal (B) shown below. Then connect the battery terminal (D) from the first EBM to the battery terminal (E) of the
second EBM. The user then needs to reassemble the front panel
STEP SIX
Plug the UPS into a mains power socket and turn the power on. The UPS will power on in bypass mode and begin charging
STEP SEVEN
To switch the UPS from bypass mode to online. Press and hold for button for longer than 3 seconds. After a short while, the LCD
display will show
signalling that the UPS is powered and protecting the equipment.
Read the UPS safety instructions back-feed protection requirements page 7
