C300R User Manual
Page 17
Battery capacity
level indicator
This light indicates the amount of battery capacity
remaining. Each battery capacity level bar indicates 20%
of the total battery capacity.
Load capacity
level indicator
Indicates the percentage of the UPS load capacity
which is being used by the protected equipment. Each
LCD level bar indicates 20% of the total UPS output
capacity.
LCD DESCRIPTION
The table below gives details on the information provided by the UPS:
OPERATION STATUS
CAUSE
STbY
The UPS is currently in standby mode.
IPVL
The input voltage is too low. (below minimum operating conditions)
IPVH
The input voltage is too high. (above maximum operating conditions)
IPFL
The input frequency is too low. (below minimum operating conditions)
IPFH
The input frequency is too high. (above maximum operating conditions)
NORM
The UPS is operating under normal conditions. Equipment is being powered from the mains supply, not from the UPS
batteries.
AVR
The UPS is operating in AVR mode.
bATT
The UPS is providing power to equipment from the UPS batteries. This will occur if there’s a problem with the mains supply.
UPS will follow shutdown procedures established using the WinPower Software.
TEST
The UPS is currently set to perform tests on the batteries.
OPVH
Displayed during battery operation if the input voltage is too high. (above maximum operating conditions)
OPVL
Displayed during battery operation if the input voltage is too low. (below minimum operating conditions)
IF ANY OTHER STATUS APPEARS, OR FOR FURTHER GUIDANCE ON WHAT TO DO PLEASE SEE THE TROUBLESHOOTING
SECTION ON PAGE 25 OR CONTACT A CertaUPS REPRESENTIVE
IF AN ERROR CODE APPEARS PLEASE REFER TO THE ALARMS AND FAULTS SECTION OF THE MANUAL PAGE 25
OR
CONTACT YOUR CertaUPS REPRESENTIVE
