CertaUPS C300R, Руководство по установке

Страница: 8 / 19

6
5. Once the EBM has been successfully connected to the
UPS and the front panel has been reassembled correctly
the UPS needs to be configured to recognise the EBM
has been installed. To do this, refer to the instructions
on page 16.
6. Finally after configuring the UPS to recognise the EBM,
the protected equipment can be reconnected to the UPS.
Please make sure that the load equipment is turned off
before connecting all loads into the output C13/C19
ports.
2.2 Connecting the EBM in Rackmount Configuration:
Connecting EBMs in rack form will take up additional rack
space. Please ensure that you have adequate room within the
rack prior to installation.
Please Note: Remember to disconnect the protected
equipment and power down the UPS before installing any
EBMs. This will prevent damage to the equipment and reduce
the chance of electrical shock.