Drill Operations
Torque Settings
The cordless screwdriver is fitted with a mechanical torque
selector.
The torque for a specific size of screw is selected with the set-
collar (1). The correct torque depends on several factors:
•
the type and hardness of the material
•
the type and length of screws
•
the requirements needed to be met by the screwed joint
The clutch disengages with a grating sound to indicate when the set torque is
reached.
Note
: the tool must be at a standstill when the torque is being set with the
setting ring.
Drilling
For drilling purposes, move the set-collar to the last step
“drill”. In this setting, the slip clutch is inactive.
The maximum torque possible will be used in drilling mode.
Forward/Reverse switch
With the slide switch (3) above the ON/OFF switch, you can
select the direction of rotation of the battery powered
drill/screwdriver, and secure it against being switched on
accidentally. You can choose between clockwise and
anticlockwise rotation. To avoid causing damage to the gearing it
is advisable to change the direction of rotation only when the tool
is at a standstill.
The ON/OFF switch is blocked when the slide switch is in the centre position.
ON/OFF switch
Variable speed control is possible with the ON/OFF switch (4). The further you
press the switch, the higher the speed of the battery powered drill-screwdriver.
Changing from 1
st
Gear to 2
nd
Gear
You can work at a higher or lower speed depending on the position
of the selector switch. To avoid damaging the gear unit you should
only change over gears when the tool has stopped.
8
Содержание VDRILXACT
Страница 1: ......
