Before Starting Work
•
It is recommended that the tool power be supplied by a residual current
device with a rated residual current of 30mA or less.
•
Examine the location where the device is to be used for hidden electrical
cables, or gas and water pipes.
•
Before connecting the unit to the mains, ensure that the mains supply and
power cables match the details on the rating plate.
Fitting and changing tools
The unit is equipped with an SDS-plus attachment system.
•
Clean tools, then grease with a thin layer of machine grease before fitting.
•
Pull the fastening sleeve (A Fig 2) back and hold.
•
Push and rotate the dust-free tool into the tool holder as far as it will go.
The tool will lock automatically.
•
Check that it is locked in position by pulling on the tool.
Removing the SDS-plus tool
•
Pull back the fastening sleeve (A), hold and remove the tool.
Starting Work
Switching ON/OFF
•
Switching on: Press the operating switch (3).
•
Switching off: Press the operating switch (3) briefly, then release.
Handle attachment
For safety and accuracy reasons, only use the hammer drill with the handle
attachment fixed.
You will be able to obtain a safe body position when working by rotating the
handle attachment. Loosen and turn the handle attachment in an anti-clockwise
direction, then tighten the handle attachment.
Speed control
Adjust the rotate speed and impact number through revolving the adjustment
dial. It marks the lowest speed up to the max top speed on the dial.
Dust collection device
Before carrying out hammer drilling work vertically overhead, pull the dust
collecting device over the drill bit.
5
(Fig 2)
(Fig 3)
(Fig 1)
(Fig 4)
(Fig 5)
(Fig 6)
Содержание CTJCKHMROTA
Страница 1: ......
