CEP Terminals CT63 NG, Руководство пользователя

Страница: 21 / 27

21

URC “Ring” will appear

Send the AT command “AT^SPOW=1,0,0”
Power consumption table
[mA] @ 5V [mA] @ 12V [mA] @ 24V [mA] @ 32V
Low power mode 2,1 1,5 1,6 1,7
Table 7: Power Consumption in Low Power Mode with RS232 under DTE control
5.4.2 Low power mode with Looped RTS/CTS
Enabling the low power mode:

Wait until the GSM module is logged into the GSM network

Send the AT command "AT^SPOW=2,2000,3" (activating the serial interface for 2000 ms = 2 s to receive
the wake-up AT command)

A stable low-power mode should be achieved after approx. 1-2 minutes.
Disabling the low power mode by user:

A deactivation is possible while the serial interface is active (the duration of this active state was
configured during the activation of the low power mode, i.e. in this case 3 ms).

While in active state, send the following command to disable the low power mode: “AT^SPOW=1,0,0”
Disabling the low power mode upon receiving GSM activity

Call the number of the SIM card inserted in the modem, or send an SMS message

URC “Ring” will appear

Send the AT command “AT^SPOW=1,0,0”
Power consumption table
[mA] @ 5V [mA] @ 12V [mA] @ 24V [mA] @ 32V
Low power mode 14,2 6,8 5,8 4,8
Table 8: Power Consumption in Low Power Mode with Looped RTS/CTS
5.5 Operating states / green LED
The modem has a green power up LED, as depicted below, which is used to indicate various operating
states. These states are described in following table.
SLED = 2,50 Operating state of CT63 Terminal green LED state
Device off Permanently off
net search / not registered / Fast blinking (500ms on/500ms off)
registered full service Slow blinking (500ms on/3990ms off)
A call is active Fast blinking (50ms on/990ms off)
Table 9: Operating states of the green LED