T600 GASSER CONVERSION
Page 11
LANDING FRAME STRUCTURE
2
1
3
13
12
4
9
8
7
6
5
10
11
CNM2.5x8CS
CNM4x20CS
CNM4x10FW
CNM3x7FW
CNM3x4SS
CNM3x18CS
1
2
3
4
5
6
7
8
9
10
11
12
No.
Description
Qty
Part #
13
4
Skid End Caps(
脚架塞
)
HW3123A
M2.5x8 Cap Screw(
杯头内六角螺丝
)
CNM2.5x8CS
CNM3x7FW
3x7x1 Washer(
垫片
)
M4X20 Cap Screw(
杯头内六角螺丝
)
CNM4x20CS
2
1
Front Engine Mounting Block (
引擎固定块
)
HW6117G3A
1
Landing Gear Frame(
引擎座底板
)
1
HW6117G30
Plastic Struts(
脚架
)
2
HI6122D
4
HW3123B
Aluminum Skids with Caps (
脚架弯管
)
CNM3x7FW
3X7X1 Washer(
垫片
)
CNM3x4SS
M3x4 Set Screw(
无头内六角螺丝
)
M3x18 Cap Screw(
杯头内六角螺丝
)
CNM3x18CS
M4X20 Cap Screw(
杯头内六角螺丝
)
CNM4x20CS
CNM4x10FW
4X10X1 Washer(
垫片
)
2
2
4
4
2
4
When installing the engine assembly to
the frames, do not tighten one side all
the way leaving the other side complete-
ly loose. Tighten the M4x20 bolts on
either side of the frames evenly moving
from one side to the other. Make sure
to apply medium threadlock to these
bolts prior to installation. After you have
installed the left and right M4x20 bolts,
install the front engine block making sure
to use medium threadlock on the M4x20
bolt holding the engine’s head in place.
Install the landing skids onto the landing struts one
side at a time. After installing the landing skids, posi-
tion, the landing struts on the skids so that they match
up with the mounting positions on the frames. Place
the washers onto the M3x16 cap screws and then
apply medium threadlock. Install the screws through
the landing struts and tighten onto the frames. Turn
the landing skids so that the curve towards the front
is facing straight up. Install the four M3x4 set screws
to lock the skids into place. Do not tighten these too
much as you can crack the plastic struts. Lastly, in-
stall the landing skid stoppers.
CA
