2
With stroller laying face down
on floor, slide
Brake Housing
onto rear leg until it
clicks
in
place.
NOTE:
Brake levers
must
face
rear of stroller.
Repeat for opposite leg.
3
While holding
Axle Sleeve
between
Brake Housings
, slide
Axle
through
Brake Housing
,
Axle Sleeve
and opposite
Brake
Housing
.
4
Secure
Wheel
to
Axle
:
• Slide
Wheel
onto
Axle
with
Ribs
facing in.
• Push
Wheel Retainer
onto end of
Axle
while supporting
opposite end of
Axle
(to keep
Axle
from sliding).
Wheel
Retainer
will snap into groove on end of
Axle
.
NOTE:
Make sure large end of
Wheel Retainer
is towards
Wheel
.
• Snap
Retainer Cap
over
Wheel Retainer
.
• Line up
Hub Cap
tabs with slots in
Wheel
and snap
Hub
Cap
in place.
Repeat for opposite wheel.
4
ASSEMBLY continued
CAUTION:
• Failure to install retainer cap may cause wheels to come
off of stroller.
• After wheel assembly is complete, pull on wheels to check
that they are secure.
Hub
Cap
Retainer
Cap
Wheel
Retainer
Wheel
Brake
Housing
1
Rotate both
Locking Levers
to
open position as shown.
2
Snap one end of cup holder
over stroller frame above
handle locks, rotate down to
opposite side and snap in
place.
3
Rotate both
Locking Levers
over handle tubes to secure
cup holder to handle.
Attaching Cup Holder
Ribs
Axle
WARNING
• To avoid burns, never put hot liquids in cup
holder.
• Avoid possible tipping. DO NOT place more
than 3 lbs. (1.4 kg) in cup holder.
Axle
Sleeve
Locking Levers
Brake
Housing
Axle
Sleeve
Axle
Locking Levers
