Assemble the support bridge with M3 hardware. Press each
side onto the support strut and secure with the cable tie
wraps provided.
Cable Tie x 4
SE & Max 90
only.
#HI6082 Tail
Support Bridge
M3x15 Socket
Screw, M3x8
Flat Washer x 2
& M3 Locknut
Slide the two tail pushrod clamps over the unfinished end of
the tail pushrod and attach to the tail boom. Press the ball
link onto the steel ball on the tail pitch bellcrank. Position
the one guide infront of the horizontal fin and one half way
between the fin and the mechanics bringing the pushrod to
the right side of the helicopter.
Tail pushrod
with one end
assembled.
#HI6106
Adjustable Tail
Guides
Remove the pushrod from the servo and slide through the
entire range of movement. Continue adjusting the guides
until the pushrod moves very smooth and then secure the tail
guides with the cable ties.
Assemble the other pushrod end cap and ball link to mark
and cut the tail pushrod to match the steel ball on the servo.
Bond the end cap in place and fine tune the position by
moving the rudder servo mount and then tighten in place.
Cut, sand and bond the
tail pushrod end cap.
Tighten after final
positioning.
Slide the M3 socket screws through the mounts on the tail
gear box and attach the forward gear box mount capturing
the tail boom and secure in place with M3 locknuts.
#HI6068 Forward
Gearbox Mount
M3 Locknut x 4
Carbon or
Plastic
Vertical Fin
91
92
93
96
95
94
18
#HI6067A Carbon
Vertical Fin
#HI6067 Plastic
Vertical Fin
M3x35 Socket
Screws x 2
M3x45 Socket
Screws x 2
Short
Spacers x 2
Long
Spacers x 2
#HI6068
Vertical Fin
Mount half
Insert the M3 socket screws through the holes in the carbon
vertical fin. Slide the short spacers on the front bolts and the
long on the rear bolts. Slide the vertical fin mount on after
the short spacers.
