24
FREQUENTLY ASKED QUESTIONS
WHAT DO THE WORDS “DRAFT” AND “NEGATIVE PRESSURE” MEAN?
The word
“draft”
refers to the hot air movement that circulates in your stove’s exhaust
system, moving from the stove to the outside of the house, and carrying with it the
combustion residues. The draft is a natural phenomenon. Hot air weights less than cold
air, causing it to rise. This is why the higher the temperature in the exhaust system, the
stronger the draft. It is also important to say that the “tunnel effect” created by the exhaust
system contributes to increasing the draft effect. This is why chimneys that are
excessively long often create excessive draft, while chimneys that are abnormally short will
have an excessively low draft. The following are often symptoms of a draft problem:
-
Excessively dirty (blackened) glass;
-
A fire that has a tendency to die quickly when the stove door is closed;
-
A stove that does not heat enough.
“Negative pressure”
can be seen as a “reverse draft”. That is, air will circulate from the
chimney toward the interior of the house. Negative pressure is often what causes
smoking problems. In general, negative pressure is the result of either one or a
combination of the three factors explained below:
1- A cold chimney. Cold air, which is heavier than hot air, has a tendency to go down
the chimney and create the effect of a “clog”. This explains why a stove that has
not worked for a long time and which chimney is very cold will sometimes be hard to
light and cause smoking problems.
2- Negative pressure can also be caused by a “vacuum effect” in the room or the
house. The air in a house is constantly moving. Hot air rises, cold air moves down.
Air can also be mechanically expulsed outside of the house with the use of air-
moving devices, such as a range hood, a air exchanger, a dryer, a bathroom fan,
etc. Furthermore, air goes in and out of the house through cracks, doors, windows,
etc. If air leaves a room without being replaced, a “vacuum effect” is created.
Therefore, if a house is well insulated and all windows are closed, the room will
source its air through the easiest alternative route, which is often your stove’s
exhaust system. This creates a negative pressure in your exhaust system. You
now understand why it is often suggested that a window be slightly open in the
room where the stove is located. This enables the room to easily source its air from
outside the house without searching for an alternative route. The vacuum effect
can amplified when your stove is located in the basement. This is due to the fact
that your house itself acts like a chimney. Since hot air will rise to upper floors, it
will “draw” air from the basement of the house. This phenomenon is called the
“chimney stack effect”.
