®
button
Use this button to select the switching modes when
setting your central heating periods. A .:~ symbol will appear
at the right hand side of the display when a 'switch on' mode is
selected, this will disappear when a 'switch off' mode is
selected. A number (1 to 16) also appears in the display next
to the symbol, this indicates the number of the switching
mode.
Up to 8 'on' and 8 'off' switching modes can be selected.
Note
"
These must be selected in pairs with the same day or group of
days for each pair, ie 1st pair
=
1-on/2-off, 2nd pair
=
3-on/4-off
etc.
If the pairs are to be set for the whole week then all days must
be selected for each 'on'
&
'off' pair as they are set.
DAY button
Use this button to select the day of the week
when setting the timer. You also use this button to select
'groups' of days when setting your central heating periods. An
arrow is continuously visible on the display to indicate the day
of the week. When setting the operating times and choosing
the 'groups' of days, the arrows appear under each day in the
'group', these revert back to the single arrow under the day of
the week after setting the timer.
When using the day button, keep press/releasing it and the
arrow under the day of the week will advance through the
days, after the single days of the week the 'groups' of days will
appear. Five days (Monday to Friday), then weekends
(Saturday and Sunday), then six days (Monday to Saturday),
then all seven days. If the button is pressed again the arrow
disappears, press it again and it will reappear under Sunday.
If the button is kept pressed in, it will quickly advance through
the above sequence.
HR button
Use this button to set the hours for the time of day
and the 'on', 'off' times. Keep the button pressed in to advance
the time rapidly, then press/release it for individual hrs.
MIN button
Use this button to set the minutes, in the same
manner as the HR button previously described.
*+
button
Use this botton to select the Advance function
which will cause the timer to advance to the next 'on' or 'off'
period. The display will show either the
*+
symbol when you
switch to 'off' during a programmed 'on' period or both the
*+
and .:~symbols will show when you switch to 'on' during a
programmed 'off' period. The timer will return to the next
programmed 'on' or 'off' mode on completion.
R button
Use this button to clear any previous programmes,
using the tip of a pencil. The display will reset to 0.00 and
Monday will be selected. The dispiay will flash until the timer
setting switch is set toe:> and the correct date/time entered
(see next section).
TO SET THE ELECTRONIC
TIMER (SEE FIG. 2)
The timer is supplied with the following factory set default
times (available 7 days)
Program 1 On 06.30
Program 2 Off 08.30
Program 3 On 12.00
Program 4 Off 12.00
Program 5 On 16.30
Program 6 Off 22.30
These may be used or the timer can be re-programmedas:follows:
1) Press the R button to clear any previous programmes from
the memory. The display will reset and start to flash.
Set the time of day and day of the week as follows:
2(a) Set the timer setting switch to e:>and the display will stop
flashing. (b) Press the HR and MIN buttons to set the actual
57030
