Page 14 - POLOphone Intercom
Group & volume settings
Figure 7 Entry Panel Selector Switch
A
B
A
B
C
D
The volume setting depends on the number of handsets connected to the system.
1-or 2-BUTTON Entry panel configuration:
With the entry panel powered up, hold the top and bottom buttons down simultaneously for 5 seconds
(5 beeps). After the fifth beep, release the buttons. A confirmation tone will then be heard for 2
Figure 6 Entry Panel Selector Switch
2
1
A
B
seconds. The entry panel is now in Configuration Mode, and will be for 10 seconds before it times out.
While in this mode, there are two options available to the user:
· Press the top button (one beep will be heard) to set the entry panel as a one-button unit, where each
button rings both groups of handsets
Or
· Press the bottom button (two beeps will be heard) to set the entry panel as a two-button unit, where
the top button rings group “A” handsets and the bottom button rings group “B” handsets.
On power up, the entry panel will beep either once or twice to indicate the configuration selected (one
beep for a one-button and two beeps for a two-button entry panel)
Handset call group selector switch and volume control
Each handset is fitted with a selector switch(C) to allow the group number for the specific handset to
be set. Set the switch depending on which group, (A) or (B) the respective handset is required to be
linked.
Adjust the speech volume at the handset to approximately 75% by adjusting the control knob (D).
Clockwise rotation increases the volume.
Check Functions
Press the gate/door release pushbutton on each handset and check that the gate/door adjacent to
each entry panel operates.
