SKU 98635
For technical questions, please call 1-800-444-3353.
Page 8
Observe the level of oil through the
3.
Oil Sight Glass (23). The oil level
should appear between the “MINI-
MUM” and “MAXIMUM” marks on the
Sight Glass.
(See Figure A.)
Add compressor oil into the Breather
4.
(26), while checking the Oil Sight
Glass (23), until the oil level reaches
the “MAXIMUM” mark on the Sight
Glass. Do not exceed the “MAXI-
MUM” mark on the Sight Glass.
(See Figure A.)
When finished topping off the oil, re-
5.
install the Breather (26).
(See Figure A.)
BREAtHER
(26)
OIL SIGHt GLASS
(23)
FIGuRE A
Incorporate an in-line oiler, shut-off
6.
valve, regulator with pressure gauge,
and filter for best service, as shown in
the diagram on the next page.
An in-
line shutoff valve is an important
safety device because it controls
the air supply even if the air hose
is ruptured. (See Figure B.)
tool
Air
Compressor
Quick
Coupler
Air Hose
on Reel
Filter
Regulator with
Pressure Gauge
Male
Connector
Male
Connector
Valve
Quick
Coupler
Attach an air hose to the Compres-
7.
sor’s Quick Coupling (63). Then con-
nect the other end of the air hose to
the air inlet of the pneumatic tool.
Close the in-line safety valve be-
8.
tween the Compressor and the tool.
Turn on the Compressor according
9.
to the directions in this manual and
allow it to build up pressure until it
cycles off at 115 PSI.
Adjust the Compressor’s Tool Pres-
10.
sure Gauge (64) so that the air output
is enough to properly power the tool,
but the output will not exceed the
tool’s maximum air pressure at any
time. Adjust the pressure gradually,
not to exceed the maximum working
pressure.
Inspect the air connections for leaks.
11.
Repair any leaks found.
If the tool will not be used at this
12.
time, turn off and detach the air sup-
ply, safely discharge any residual
air pressure, and release the tool’s
throttle and/or turn the switch to its off
FIGuRE B