SKU 97187 For technical questions, please call 1-800-444-3353.
Page 6
OPERATION
For best service, you should incorporate an oiler, regulator, and inline filter, as shown
in the diagram below. Hoses, couplers, oilers, regulators, and filters are all available at
Harbor Freight Tools.
Note:
To connect this tool, we recommend a quick coupler/adapter (not included). Cou-
pler/adapters are available at Harbor Freight Tools. For smoother operation, put
3-5 drops of pneumatic tool oil in the Hose Joint (6) before each use.
Figure 4 — Airline Oiler Assembly
Sander/
Drill
Setup
Step 1: Set the compressor’s pressure regulator to 90 PSI. Do not set the compressor’s outlet
regulator over 90 PSI.
Step 2: Connect the Sander/Drill to the air compressor’s hose. If leaking is detected,
disconnect the air hose and repair before use.
Drilling
Note:
This tool has no safety shield.
DO NOT USE GRINDING DISCS, GRINDING WhEELS
OR CUT-OFF WhEELS WITh ThIS TOOL.
Note:
All accessories used must be rated 18,000 RPM or greater.
Step 1: Mark the material you wish to drill at the spot for the hole. Make sure your drill bit is
the correct size for the hole you need to make.
Step 2: If possible, clamp the material in a vise to make sure the material does not move or
begin to spin while drilling.
REV 01/06;
REV 03/06
