TROUBLESHOOTING
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY
DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE
OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER
AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS
SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER.
THE BUYER ASSUMES ALL RISKS AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE
ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER
INSTALLATION OF REPLACEMENT PARTS THERETO.
Problem
Possible Cause
Possible Solution
Air leaking in Cylinder Cap. 1. Loose nose Screw (13).
2. Seal (17) is cracked or worn.
1. Tighten and recheck.
2. Replace Seal.
Lack of power. Slow to
cycle. Low power when
shooting and returning.
1. Tool is too dry.
2. Air pressure too low.
3. Exhaust flocked.
1. Add about 3 drops of pneumatic
tool oil into the Air Plug (55).
2. Check to make sure regulator on
air compressor is set between 70
PSI and 90 PSI.
3. Clean exhaust channel.
Shooting no fasteners, or
intermittent feeding.
1. Damaged Pusher Spring (39).
2. Wrong size of fasteners.
3. Fixed Magazine (50) or Baffle
Plate (23) is dirty.
1. Replace Spring.
2. Use Cleat Nails 1-1/2 to 2” long
or Staples 3/4 to 2” long.
3. Clean Fixed Magazine and
Babble Plate.
Fastener is jammed in tool. 1. Driver channel is worn.
2. Piston Assy. (9) is broken or worn.
3. Bent fasteners.
1. Replace Baffle Plate (23).
2. Replace Piston Assy.
3. Remove Bent fasteners. Replace
with Cleat Nails 1-1/2 to 2” long or
Staples 3/4 to 2” long.
SKU 97586
95658
For technical questions, please call 1-800-444-3353
PAGE 11
