Page 6
For technical questions, please call 1-800-444-3353.
SKU 93212
do not oPerate With anY
6.
guard disaBLed, daMaged, or
reMoVed. Moving guards must
move freely and close instantly.
Rotate workpiece by hand before
7.
applying power.
Rough out workpiece before installing on
8.
faceplate.
Do not mount split workpiece or one
9.
containing knot.
Use lowest speed when starting new
10.
workpiece.
Do not reverse motor direction while the
11.
lathe is in motion.
Do not clear chips by hand or when
12.
lathe is running. Use a brush to sweep
chips away after the tool has come to a
complete stop.
Select the proper tool for the job. Using
13.
the correct tool for the job produces a
better finish and minimizes strain on the
lathe.
The use of accessories or attachments
14.
not recommended by the manufacturer
may result in a risk of injury to persons.
When servicing, use only identical
replacement parts.
Support pieces extending beyond the
15.
headstock so they cannot cause injury to
the operator, bystanders or lathe. Turn
supported long stock at slower RPM’s.
Use a chuck cradle or piece of plywood
16.
to protect the precision ground ways and
your hands when servicing chucks.
Check that the workpiece, tool, tool post,
17.
chuck and saddle all have adequate
clearance before starting the lathe.
Check that no part of the tool, tool
18.
holder, compound slide, cross slide, or
carriage will contact the chuck during
operation.
Use the appropriate feed and speed
19.
rates for the project.
Allow the lathe to reach its full speed
20.
before beginning a cut.
Only use safety equipment that has been
21.
approved by an appropriate standards
agency. Unapproved safety equipment
may not provide adequate protection.
Eye protection must be ANSI-approved
and breathing protection must be
NIOSH-approved for the specific hazards
in the work area.
Industrial applications must follow OSHA
22.
guidelines.
Maintain labels and nameplates on
23.
the tool. These carry important safety
information. If unreadable or missing,
contact Harbor Freight Tools for a
replacement.
Avoid unintentional starting. Prepare to
24.
begin work before turning on the tool.
People with pacemakers should
25.
consult their physician(s) before use.
Electromagnetic fields in close proximity
to heart pacemaker could cause
pacemaker interference or pacemaker
failure.
WARNING: Some dust created by power
26.
sanding, sawing, grinding, drilling, and
other construction activities, contains
chemicals known [to the State of
California] to cause cancer, birth defects
or other reproductive harm. Some
examples of these chemicals are:
• Lead from lead-based paints
• Crystalline silica from bricks and
cement or other masonry products
• Arsenic and chromium from chemically
treated lumber
