Page 10
SKU 90589
For technical questions, please call 1-800-444-3353.
Re-attach the Plastic Cover (116), and re-tighten the three Screws (113 & 129).
14.
If using wooden blocks to support the Vertical Arm (120), remove the blocks.
(See Figure b-2.)
NOTE:
15.
For shipping purposes, the Shovel (315) is restrained with a
temporary
tie-down bracket. Make sure to remove and discard the bracket.
(See Figure A.)
Lay out the Tool Box (IT42) and Tool Box Support (IT38).
16.
(See Assy. diagram.)
Attach the Tool Box Support (IT38) to the Body (1) of the Tire Changer, using the
17.
Mounting Bracket Bolts.
(See Assy. diagram.)
Attach the Tool Box (IT42) to the Tool Box Support (IT38), using the Mounting
18.
Bracket Bolts.
(See Assy. diagram.)
Remove the Left Side Cover (8) from the Body (1) to expose the inside of the Tire
19.
Changer.
(See Assy. diagram.)
Run the Hose (IT15) through the opening in the Body (1) of the Tire Changer.
20.
Then, connect the Hose to the 5-Way Valve (IT17).
(Note location in Assy. diagram.)
Re-attach the Left Side Cover (8) to the Body (1) of the Tire Changer.
21.
(See Assy. diagram.)
Assembly of the Tire Changer should be complete and the machine now ready
22.
to operate.
Only set up and use the Tire Changer on a flat, level surface that is
capable of supporting the weight of this heavy tool (566 lb.) and all required tools
and tires.
REV 07g
OpERATING INSTRUCTIONS
To perform preliminary Operating Tests:
Plug the Power Cord into the nearest 220 volt, grounded, electrical outlet.
1.
Connect the air compressor’s supply hose (not included) to the Filter & Pressure
2.
R Lubr. (IT201 thru IT205). Set the air compressor’s regulator to no
more than 110 PSI. Turn on the air compressor, and allow sufficient time for
adequate build-up of compressed air.
(See Figure A.)
Depress the Reverse Pedal (401) down. The Turntable (201) should turn in a
3.
clockwise direction. Pull the Reverse Pedal up, and the Turntable should turn
counterclockwise.
(See Figure A.)
Open the Bead Breaker Arm (321) manually, and depress the Bead Breaker
4.
Pedal (402). The Bead Breaker Arm will close. When the Bead Breaker Pedal is
released, the Pedal should return to its original position.
(See Figure A.)
