Page 14
For technical questions, please call 1-800-444-3353.
SKU 67414
tecHnical
speciFications
Engine Type
1.5 Horsepower / 52cc
Single Cylinder
2 stroke / Recoil Start
Bore x Stroke
44 x 34
Compression Ratio
8.2:1
Displacement
52cc
Rotation
viewed from PTO
(power takeoff - the output shaft)
Clockwise
Fuel
Type
25:1 - 89+ octane
unleaded gasoline to 2
cycle oil mix
Capacity
.26 Gallons
Recommended Gear
Oil
SAE 80-90 Weight Gear
Oil
Spark
Plug
Compatible
Types
NGK BPM7A
Bosch WS7F
Champion CJ7Y
Torch L7T
(resistive plugs only)
Gap
0.028~0.031”
Drilling Speed
150 RPM
servicinG
to prevent
serious injurY
FroM accidental
startinG:
turn off the engine, wait for
the engine to cool, and
disconnect the spark plug
wire(s) before performing any
inspection, maintenance, or
cleaning procedures.
to prevent
serious injurY
FroM eQuipMent Failure:
do not use damaged
equipment. if abnormal noise,
vibration, or excess smoking
occurs, have the problem
corrected before further use.
Maintenance procedures
Many maintenance procedures,
including those not detailed
in this manual, will need to
be performed by a qualified
technician for safety. if you
have any doubts about your
ability to safely service the
equipment or engine, have a
qualified technician service the
equipment instead.
note:
Warranty is void if proper
maintenance and servicing
procedures are not followed.
daily Maintenance
before each use:
1.
Inspect the
general condition of the Auger Drill.
Check for misalignment or binding
of moving parts, cracked or broken
parts, dull or damaged Auger (33a),
and any other condition that may
affect the safe operation of the tool.
An Auger (33a) that is bent or packed
2.
with dirt and debris can cause
personal injury. Replace a damaged
Auger and keep the Auger clean at all
times.
Check the Air Filter (78) prior to each
3.
use for excessive dirt and debris
buildup, clean as needed.
Check the gear oil level in the
4.
Gearbox (8a) prior to each use, and
fill as needed with SAE 80-90 weight
gear oil.
After each use, use a clean cloth and
5.
mild detergent to clean the exterior
of the engine. Do not use solvents.
Remove the Auger (33a) from the
engine and use a garden hose to
