Page 12
For technical questions, please call 1-800-444-3353.
SKU 67414
Idle Screw
Choke
Figure 6
WarninG!
The Auger (33a) should not
turn at idle. If it is turning at idle,
shut off the engine by releasing the
Speed Control (10b) and pressing
the Kill Switch (5b), disconnect the
spark plug, then turn the Idle Screw
of the Carburetor (shown above)
counterclockwise
to reduce the idle
RPM, or immediately discontinue
using the Auger Drill and contact a
qualified service technician to make
the adjustment.
Once the Engine is started, open the
6.
Choke (76).
If the Engine
7.
does not
start, press the
Primer (95) again. Close the Choke
(76) if it is open, and again attempt to
start the Engine.
Figure 7
Speed
Control
(10b)
8. As soon as the Engine is running,
check to make sure the Choke (76)
is open. Squeeze the Speed Control
(10b) briefly and let up. The Speed
Control will revert to its original
position, causing the Engine to idle.
Keep your thumb near the Kill
switch in the event the auger drill
must be stopped immediately.
(see Figure 8.)
Figure 8
Kill Switch (5b)
9. To stop the Auger Drill when needed,
release pressure on the Speed
Control (10b). Then, press down on
the Kill Switch (5b).
Stand with a solid stance on stable
10.
ground. Brace yourself and maintain
a proper grip with both hands on the
Frame (1b) whenever the Engine is
running.
