Page 7
For technical questions, please call 1-888-866-5797.
Item 63469
S
AFET
y
Op
ERA
TION
M
AINTENAN
c
E
S
ETU
p
Setup - Before Use:
Read the ENTIRE IMpORTANT SAFETy INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION:
Turn the power Switch of the tool off and unplug the tool from its electrical outlet
before performing any procedure in this section.
Note:
For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
Assembly/Mounting
WARNING!
To assemble and locate the Bandsaw will
require additional assistance and a proper lifting device.
1. After the Bandsaw and its accessories
are unpacked, make sure its Head is
lowered to its horizontal position.
2. With a proper lifting device, raise the
Bandsaw approximately six inches off
the floor surface. (See Figure A.)
Figure A
3. Once the Bandsaw is lifted, insert the
Wheel Rod (92-4) through the two holes located
at the bottom/right side of the Stand (77S).
Slide one Wheel (92-2) on each end of the
Wheel Rod. Place one Washer (92-1) on each
end of the Wheel Rod. Insert one Cotter Pin
(92-3) through the hole in each end of the
Wheel Rod. Make sure to bend the Cotter Pins
to secure the Wheels in place. (See Figure B.)
4. Screw in the two Levelers (93) into the two
threaded mounting holes located underneath
the bottom/left side of the Stand.
5. Carefully lower the Bandsaw to the floor
surface. Then turn the two Levelers clockwise or
counterclockwise to properly level the Stand.
6. Attach the Hand Rod (98-1) to the Stand
Assembly using Screw (98-2), Washer (98-3)
and Hex Nut (98-4). Refer to the
Diagrams shown later this manual.
WHEEL ROD
WHEEL
WASHER
cOTTER pIN
STAND
LEVELER
Figure B
NOTE:
The Bandsaw is factory pre-wired to operate
on a grounded, 120 volt, 60 Hz, 1-Phase system.
See pages - 31 for additional wiring options
that only a licensed electrician should attempt.
WARNING! Only a licensed electrician
should attempt to rewire the Bandsaw.
