Page 15
For technical questions, please call 1-888-866-5797.
Item 63469
S
AFET
y
Op
ERA
TION
M
AINTENAN
c
E
S
ETU
p
• Position Slot (A) over the small
rectangular opening across the Base.
• Attach Screws (A and B). Align the lower
edge of the Rear Vise Jaw with the “0” index
mark adjacent to the 16° degree setting.
Tighten the screws. (See Figure P)
A
D
B
Figure p
To Adjust The Stop Block
For repeated cuts of pre-set lengths:
1. Loosen the Thumb Screw (38) that
holds the Stop Block (41) to the Stock
Stop Rod (40). (See Figure Q)
2. Adjust the Stop Block to the desired length
position. Then re-tighten the Thumb Screw.
THUMB
ScREW
STOcK
STOp ROD
STOp
BLOcK
WORKpIEcE
(NOT
INcLUDED)
Figure Q
To Adjust The Blade Guide Brackets
1. The Blade Guide Knob (261) is adjusted by
loosening the Knob and sliding the Blade Guide
Bracket (269S) up or down to accommodate
the width of the workpiece. (See Figure R.)
2. The Blade Guide Bracket should be set
as close as possible to the workpiece,
without interfering with the workpiece.
3. Retighten the Blade Guide Knob.
BLADE GUIDE BRAcKET
BLADE GUIDE
KNOB
Figure R
