For technical questions, please call 1-800-444-3353.
SKU 38123
Page 11
BASE (42)
WASHER (8)
KNOB (1)
INDEX PIN
TABLE SUPPORT (36)
1/16” MAX. BETWEEN
SANDING SURFACE
WORKTABLE EDGE
TABLE
ANGLE SCALE
FIGURE G
BACKSTOP (9)
HEX SCREW (6)
LOCK WASHER (7)
FLAT WASHER (8)
WRENCH
(NOT INCLUDED)
BED (4)
FIGURE H
OPERATING INSTRUCTIONS
To Adjust The Worktable For Vertical Sanding:
1.
Remove the Hex Screw (6), Lock Washer (7), and Flat Washer (8). Then, remove the
Backstop (9). (See Figure H.)
2.
Unscrew and remove the Knob (1). (See Figure I, next page.)
3.
Pull the Index Pins out of the mounting holes in the Table Support (36).
(See Figure G.)
To Install The Backstop:
Place the Backstop (9) over the Bed (4), and use a Hex Screw (6), Lock Washer (7),
and Flat Washer (8) to secure the Backstop to the Bed. The Backstop must not be in
contact with the Sanding Belt (10). (See Figure H.)
