CentoLight ZEPHIRO HAZE 1000ST, Руководство пользователя

Страница: 10 / 36

10 10
Zephiro Haze 1000ST User Manual
Eng
The earth must to be connected! Pay attention to the safety! Before taking into
operation for the first time, the installation has to be approved by an expert.
FUSE HOLDER (n.11) - In case you need to replace the fuse, make sure that the
appliance is switched off, disconnect the input power plug, and unscrew the fuse
holder cover shown above with a Phillips screwdriver.
CAUTION: Replace the fuse ONLY with one of the same type indicated in the
section “7 - Specification” on page 17 (T10A/250V - 5x20 mm). A lower value
fuse would blow immediately after the first power on; a higher value would not
act as a fuse in case of anomalous current absorption or short circuit.
WARNING: Always connect the product to a protected circuit (with circuit break-
er). Make sure the machine has an appropriate electrical ground to avoid the
risk of electric shock or fire.
WARNING: Never connect the Zephiro Haze 1000ST to a rheostat (variable
resistor) or dimmer circuit, even if the rheostat or dimmer channel serves only
as a 0 to 100 % switch.
4.2. DMX Connection
3PIN
5PIN
DMX IN DMX OUT
4 5 6 7
DMX INPUTS - Male 3-pin (n. 5) and Male-5-pin (n. 4) XLR sockets for connection to
DMX control devices.
DMX OUTPUT - Female 3-pin (n. 6) and Female 5-pin (n. 7) XLR sockets for sending
the DMX control signal to another DMX device.
DMX machines are designed to receive data through a serial Daisy Chain. A Daisy
Chain connection is where the DATA OUT of one fixture connects to the DATA IN of
the next fixture. The order in which the machines are connected is not important
and has no effect on how a controller communicates to each of them. Use an order
that provides for the easiest and most direct cabling.