Page 10
For technical questions, please call 1-888-866-5797.
Item 62374
SAFETY
O
PERA
TION
M
AINTENANCE
SETUP
Maintenance and Servicing
Procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY: Unplug the Power Pack, turn the Clamp Power Switch off and allow
Power Pack to cool completely before performing any inspection, maintenance, or cleaning procedures.
1.
BEFORE EACH USE,
inspect the general
condition of the Power Pack. Check for:
• loose hardware,
• cracked or broken parts,
• damaged electrical wiring or cable insulation, and
• any other condition that may
affect its safe operation.
2. Keep unit clean and clamps free
of dirt, debris, or grease.
3. For longer working life, protect Power
Pack from sunlight and moisture.
4.
AFTER USE,
wipe external surfaces of
the Power Pack with clean cloth.
5.
CONTAINS NON-SPILLABLE, SEALED LEAD-
ACID BATTERY. BATTERY MUST BE RECYCLED.
Battery Replacement and Disposal
LEAD BATTERY MUST BE RECYCLED.
WARNING! To prevent damage or injury, replacement battery must be identical to original.
Replace the Battery when the red light comes on while
pressing the Battery Test button after recharging.
1. Remove all screws from the back of
the case and lift off the panel.
2. Lift out the Battery without damaging the circuit board.
Note:
Notice how the red and black cables connect
to the old battery and make sure to keep them in
place, connecting them to the new battery.
3. Detach the recharging wires and Battery
Cables from the battery terminals.
4. Position the replacement battery with the label
facing out, and make sure the
red (+)
recharging
wire and Battery Cable is attached to the
positive (+)
battery terminal. Connect both of
the recharging wires and Battery Cables.
5. Carefully slide the Battery into the compartment
without damaging the circuit board.
6. Replace the back panel and the screws.
Call 1-800-822-8837 for battery recycling.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM
IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR
MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS
QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE
ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY
STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND
LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY
ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS
THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
