Belt & Agitator Changing/Replacement
Agitator Cleaning
To Clean Agitator
NOTE:
In order to keep cleaning
efficiency high and to prevent
damage to your powerhead, the
agitator must be cleaned every time
the belt is changed. The agitator
must also be cleaned according to
the following schedule.
Vacuum Cleaner Use
HEAVY -
(Used daily)
MODERATE -
(Used 2-3 times/week)
LIGHT -
(Used 1 time/week)
Clean Agitator
every week
every month
every 2 months
IMPORTANT
Disconnect powerhead from electrical outlet. Check and remove hair, string
and lint build-up frequently in the powerhead agitator and end cap areas.
Remove any dirt or debris in the belt path area or in the brush roller area.
Carefully remove string or debris located on the agitator or end caps.
1) Turn the nozzle upside
down and unscrew the screws
located below.
Agitator Assembly
To Replace Belt
To Replace Agitator
2) Locate and pull the tabs
shown below on the back of
the nozzle.
3) Take the black top casing off
of the nozzle.
4) Remove the clear plastic
covering over the agitator.
5) Lift both sides of the agitator
out of the holding slots and
pull it through the belt loop.
After removing the agitator
you can remove the belt from
the motor.
To Replace Light Bulb
After taking off the black top
casing locate the light bulb
and pull it out, then simply
push the new bulb in.
End Cap
Belt Path
End Cap
Brush Unit
