18
7. ALARMS
ENGLISH
Alarms can occur at start up or during operation of
the machine and cause electronic blocking of
the machine with a subsequent motor shut-off .
They are associated with a double visual indication:
blinking of the LEDs with red light.
fl ashing of the screen on the display.
The alarm will cause the motor to shut-off . In order to reset the alarm:
- Move the switch (8) to the OFF central position.
- Remove and reinsert the battery, the alarm is reset only if the conditions of use are within
parameters to safely operate the machine without damage.
Verifi able alarms are summarised in the following table:
Display screen
Error description
S
olution
BATTERY
Battery low.
Replace or recharge the battery low.
BATTERY
Damaged battery.
Replace the battery.
BATTERY
Temperature of the battery is too low
caused by low ambient temperature or
too high caused by intensive use.
Replace the battery or wait for heating or
cooling.
MOTOR
Overheating of the motor caused by in-
tensive use or high ambient temperature.
Wait for the motor to cool down then re-start the
machine.
MOTOR
A
Abnormal current consumption of the
motor.
Remove and re-insert the battery, then re-start
the motor.
If the problem persists, please contact Cembre.
DRIVER
Overheating of the electronic control
card caused by intensive use.
Wait for the electronic card to cool down.
If the problem persists, please contact Cembre.
NTC
FAULT
Interruption of the signal from the NTC
temperature probe of the battery.
Replace the battery.
If the problem persists, please contact Cembre.
The auger rotation is obstructed, blocked
spindle or rotation with too low speed
(for example blocked auger in the sleeper,
gears broken, too hard material).
Remove what is blocking the spindle’s rotation and
re-start the motor.
If the problem persists, please contact Cembre.
!
......
Self diagnosis with a negative out
come.
001....003 fi rmware errors.
Remove and re-insert the battery and re-start
the motor.
If the problem persists, please contact Cembre.