Cembre B-TC250YA, Руководство по эксплуатации и обслуживанию

Страница: 6 / 12

6
Do not use the tool for purposes other than those intended by
Cembre
.
The operator should concentrate on the work being performed and be careful to maintain balanced
working position.
Work in a clean, uncluttered area. Keep persons away from immediate work area.
Inspect the blades before each use. Do not use damaged blades.
Damaged blades can break and cause injury or damage to the tool.
Before each use, verify the integrity of the tool; replace any worn, possibly damaged or missin
parts with original
Cembre
spares.
Wear eye protection. Metal chips can fl y from blades when cutting.
Pay attention when cutting short, free pieces of steel rod or rope as they may fl y off dangerously,
causing injury to the operator or persons nearby.
Do not cut live cables or conductors.
The tool is unsuitable for continuous use and should be allowed to cool down following uninte
upted, successive cutting operations; for instance, having exhausted a fully charged battery in
one session, delay battery replacement for a few minutes.
Protect the tool from rain and moisture. Water will damage the tool and battery. Electro-hydraulic
tools should not be operated in pouring rain.
2. INSTRUCTIONS FOR USE
The part reference includes the following:
Hydraulic cutting tool (B-TC250YNA is fi tted with adapter to use Makita battery).
Li-Ion rechargeable battery (2 pcs) (model depends on the tool version).
Battery charger (model depends on the tool version).
Shoulder strap.
Carrying case.
USB cable (Ref. to § 5).
The tool can be easily carried using either the handle or the shoulder strap attached to ring (9)
(Ref. to Fig. 6).
Before starting any work, check the battery charge (Ref. to § 2.8) and recharge if necessary.
Refer to the manufacturer's instructions for the correct use of battery and battery charger.
To
replace the battery, remove it by pressing the release button (7) (Ref. to Fig. 1a and 1b),
B-TC250YA: in the fi g. 1a press the release buttons (7) and slide the battery out unlocking it.
B-TC250YNA: in the fi g. 1b press the release button (7) and slide the battery out unlocking it.
Insert a charged battery by sliding it into the guides until it locks.
2.1) Head rotation
For ease of operation, the tool head can rotate through 180°, allowing the operator to work in the
most comfortable position (Ref. to Fig. 2 and 3).
Do not attempt to rotate the head when the hydraulic circuit is pressurised.
WARNING