SPC series
5
4.2.
PARAMETER SETTING TABLE
Weight Display
Description
F0 CAL
Please short K6 before setting.
When the parameter menu show "F0" press the TARE key.
The display will then show "
UNLOAD
" to request all weight be removed
from the platform.
After STABLE indicator on, press the TARE key to set the zero point.
The display will then show the calibration weight requested, press the
TARE key to accept it.
The display will show "
LOAD
". place the calibration weight on the scale.
After STABLE indicator on, press the TARE key. The scale will calibrate
and then start the initial check procedure counting form 9 to 0. Remove
the weight during the counting.
F1 RES
Set external resolution, press SAVE key to change (3000/60000/duag
range), press Tare key to sure.
F2 UNIT
Not available
F3 CAPA
Set capacity, Press SAVE key to select, press TARE key to sure..
F4 POINT
Set weighing decimal point, press SAVE key to select, press TARE key
to sure.
F5 POINT
Set price decimal point, press SAVE key to select, press TARE key to
sure.
F6 INIT ZERO
Not available
F7 RE ZERO
Not available
F8 SCSIUE TARE
Not available
F9 A-D COUNTS
Displays the A/D counts.
F10 cntry
Not available
F11 Fractn
Set half/quarter/100g/unit key function on or off(on/off).
F12 RS- 23 2
It has to be ALWAYS OFF
F13 Printr
It has to be ALWAYS OFF
F14 baud
Set baud rate, this parameter will available when F12 set as not off, you
can select 2400bps, 4800bps, 9600bps, 19200bps
F15 mode
Set communication mode, you can select 7E1(7 data bits, 1 stop bit, even
verify), 7O1(7 data bits, 1 stop bit, odd verify), 8n1(8 data bit, 1 stop bit,
no verify),
F16 scale
Set scale mode, you can select 0,1,2,3 1/2/3 are all mutual mode by RS-
232, normally, set scale mode as 0
F17 percnt
Set percentage tare mode, you can set as on or off. When se this
parameter as on, you can use percentage tare function, enter a values
from numeric keyboard, hold tare key for 3 second, %tare indicator on,
scale in %tare mode, the goods put on your platter will tare the values
you have set automatically.
F18 label
Set label format, not available
F19 grv
Set gravity value, input your local gravity value
F20 scale
Scale mode, not available