Series PS-50/60
49-MCEPS56EN03
USER´S MANUAL
3
When the packaging is removed, a negative value will be shown. If the scales are tared before the packaging
is removed, this value will be the gross weight of the packaging plus all the product that was removed. the
zero indicator will also light up because the platform returns to the same situation as when
was
pressed.
6.3. CHANGE UNIT OF WEIGHT
Keep
pressed for 4 seconds and the unit of weight will change. The selected unit of weight will light up
(kg or lb).
7. CONFIGURATION
7.1. ACCESS TO CONFIGURATION MODE
The scales have 7 parameters configuration parameters that can be set-up by the user, and there is also a
method for entering calibration.
To set the configuration parameters or enter in calibration, switch on the equipment while pressing
.
F0
CAL. will appear.
7.2. CALIBRATION
After entering Configuration mode, the display will show the first function "CAL". Press
and the display
will show “UNLOAD”. Ensure the plate is empty and when the STABLE indicator is activated, press
again. The display will show the calibration weight. Press
to select a calibration weight (in kg) (Ex: A0 2,
A1 4, A2 6). After selecting the weight, press
and the display will show “LOAD”. Place the calibration
weight on the scales and the STABLE indicator will be activated. Press
to save. The display will now
show “PASS”. The scale will then perform an auto-check and the scales will be ready for use.
7.3. CHANGE OF STEP
After entering Configuration mode, the display will show “F0 CAL”. Press
and the display will show "F1
INC". Press
to enter, then press
to select the 0.5 or 1.0 g step. Press
to save. Press
and
simultaneously to exit.
7.4. VERIFICATION OF INTERNAL DIVISIONS
After entering Configuration mode, the display will show “F0 CAL”. Press
twice and the display will show
the internal counts. Press
and
simultaneously to exit.
7.5. SETTING THE BACKLIGHT MODE
After entering Configuration mode, the display will show “F0 CAL”. Press
three times and the display
will show “F3 BT”. Press
to enter, then press
to change the backlight mode (AU: automatic, OFF:
desactivated, ON always activated). Press
and
simultaneously to exit.
