OPERATING YOUR HEATER
Always choose a safe location for the heater, keeping in mind the safety precautions outlined. Ensure
all packaging has been removed from the unit before use. This appliance requires no installation, it
should be used solely as a portable appliance.
WARNING: Keep all objects at least 1 metre from the front, sides and rear of the appliance.
Note: When the heater is turned on for the first time, it may release a slight, odour or smoke. This
odour or smoke is a normal occurrence caused by the initial heating of the internal heating elements
and should not occur again.
HEAT CONTROL SWITCH
The control switch positions are:
Check that the heat control switch is set to Off position before plugging the heater into the mains
supply. For greater economy, use the High Heat setting initially and then switch to the Low Heat
setting.
The heater and the thermostat work together, so if the thermostat is not set, the heater will not run.
For the Low and High Heat settings the fan remains at the same speed, only the element changes to
create the greater/lesser heat output.
THERMOSTAT
Turn the thermostat knob clockwise until you reach the maximum temperature on the graduated
scale. When the desired room temperature is reached, slowly turn the knob anti-clockwise until the
heater turns off (you will hear a click). The heater will now cycle on and off to maintain the set
temperature.
SAFETY DEVICES
This appliance has three protection devices. The first device will automatically turn the appliance off if
the appliance is not in the appropriate operating position. The second device automatically
disconnects & reconnects the appliance at a pre-set temperature. The third device disconnects the
appliance permanently in case of overheating, by means of a thermal fuse. (It is non resettable).
Do not attempt to dismantle the heater. There are no user serviceable parts. For service or repair,
contact an authorised electrical service technician.
IMPORTANT! NEVER COVER THIS HEATER!
CARE AND CLEANING
The heater requires regular cleaning to ensure trouble free operation.
Unplug the heater from the mains supply before cleaning.
Ensure that the heater has been allowed to cool down completely before cleaning.
Use a damp cloth (not wet) to wipe the exterior of the heater to remove dust and dirt.
Never use solutions such as benzene, thinners or polishing agents.
Use a vacuum cleaner to remove dust and fluff from around the grills.
Ensure the heater is dry before plugging back into the mains supply.
Do not use this heater with a programmer, timer, separate remote-control system or any other device
that switches the heater on automatically.
CAUTION: The heater generates heat during use. Proper precautions must be taken to prevent the
risk of burns, scalds, fires or other damage to persons
PROOF OF PURCHASE
To receive warranty retain receipt
as proof of purchase. (Refer to back of booklet).
Low Heat with Oscillation
High Heat with Oscillation
0
OFF
I
Low Heat
II
High Heat
TECHNICAL SPECIFICATION
Model No: CELCT200
Supply: 220-240VAC 50Hz
Wattage: 2000W
