( LOGO)
DESK AND WALL-MOUNTED ELECTRIC FIREPLACE/HEATER
BFM EUROPE LTD
Page 9
Step 7: Fit the appliance front fascia as shown below. (Figure 6)
Secure the fascia by fasten two M4×6 screws on both side.
Figure 6
CAUTION! THE UNIT’S POWER CORD MUST BE CONNECTED TO A PROPERLY EARTHED
AND PROTECTED 240V OUTLET. ALWAYS USE EARTH FAULT PROTECTION WHERE
REQUIRED BY THE ELECTRICAL CODE.
This appliance can be operated by both a remote control and a manual keypad. Once the unit has been
properly connected to an earthed electrical socket-outlet ensure the manual On/Off switch, located on
the right hand side of the appliance, is in the ‘ON’ position.
MAUNAL ON/OFF SWITCH
This switch turns the appliance on/off. The manual on/off switch must be in the ‘ON’ position when using
both remote and manual operation.
WARNING! DO NOT OPERATE THE UNIT IF IT IS DAMAGED OR HAS MALFUNCTIONED. IF
YOU SUSPECT THE UNIT IS DAMAGED PLEASE CALL A QUALIFIED SERVICE TECHNICIAN TO
INSPECT AND TO REPLACE ANY PART OF THE ELECTRICAL SYSTEM IF NECESSARY.
Your BFM fireplace/heater unit comes in four distinct parts:
The fireplace unit itself,the fascia, the pebble set and the Remote Control.
OPERATING INSTRUCTIONS
M4 x 6 Screw