Celsi B-127740, Инструкция и руководство по эксплуатации для владельца дома

Страница: 8 / 16

3.EF.39.Rev. 1.0 8
SECTION 5 : OPERATING INSTRUCTIONS
CAUTION! THE UNIT’S POWER CORD MUST BE CONNECTED TO A
PROPERLY GROUNDED AND PROTECTED 240V OUTLET. ALWAYS
USE GROUND FAULT PROTECTION WHERE REQUIRED BY THE
ELECTRICAL CODE.
This appliance can be operated by both the remote control and the manual keypad. Once
the unit has been properly connected to an earthed electrical socket-outlet ensure the
manual On/Off switch, located on the right hand side of the appliance (see below), is in the
‘ON’ position.
MANUAL ON/OFF SWITCH
Use this switch to turn the appliance on/off. Once turned
off the appliance will need to RE-BOOT before use – see
details below.
NOTE: The manual on/off switch must be in the ‘ON’
position when using both remote and manual
operation.
WARNING!
DO NOT OPERATE THE UNIT IF IT IS DAMAGED OR HAS
MALFUNCTIONED. IF YOU SUSPECT THE UNIT IS DAMAGED PLEASE
CALL A QUALIFIED SERVICE TECHNICIAN TO INSPECT AND TO
REPLACE ANY PART OF THE ELECTRICAL SYSTEM IF NECESSARY.
BOOT UP PROCEDURE:
Switch the Manual ON/OFF switch to the ON position. The screen should now appear white
for a few seconds after which the ‘boot-up’ sequence will begin.
Boot-up can take up to 2 minutes during which this hourglass icon will be seen -
When boot-up is complete this icon will be seen on the screen -
Press the ON/Standby button when prompted.
The appliance is now ON.
NOTE: If the Manual ON/OFF switch is turned to the OFF position, the heater cuts off
due to overheat or the power to the unit is interrupted, the unit will reboot once power is
restored.
3
NOTE: If this product experiences exceptionally low or exceptionally high supply
voltages it may automatically reset or stop functioning. If this occurs the product should
be unplugged or isolated from the main supply for a period of 30 seconds before the
power is then re-supplied.