Celsi B-127740, Инструкция и руководство по эксплуатации для владельца дома

Страница: 3 / 16

3.EF.39.Rev. 1.0 3
Fuse size
13amp
SECTION 1 : IMPORTANT SAFEGUARDS
WHEN USING ELECTRICAL APPLIANCES BASIC PRECAUTIONS SHOULD ALWAYS
BE FOLLOWED TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK AND INJURY TO
PERSON, INCLUDING THE FOLLOWING IMPORTANT SAFETY ADVICE.
READ ALL INSTRUCTIONS BEFORE USING HEATER.
Regarding installation of the appliance;
This appliance is supplied with a rewirable plug fitted with
a 13A fuse. Should the fuse or plug need replacing, and
you are competent to do so, it must be replaced with a 13A
fuse and the plug must be a 13amp BS1363A approved
fitted with a 13A fuse.
Connect this appliance to single-phase AC supply of the
voltage specified on the rating plate.
This heater must be earthed. If in any doubt consult a
suitable competent person.
Ensure that the plug socket-outlet connection for this appliance is accessible. It
MUST be readily accessible for easy electrical isolation in the event of servicing and
replacing components etc.
This appliance MUST NOT be located immediately below an electrical socket-outlet.
Avoid the use of an extension cord as this may overheat and cause a risk of fire.
Running this appliance on heat setting 2 (2000W) with another piece of electrical
equipment on the same circuit may cause the fuse of this appliance to blow, or your
circuit breaker to turn off the power supply. If this occurs reconnect one of the
appliances to another circuit.
This appliance is fitted with an automatic thermal cut out to reduce the risk of
damage in the event of abnormal operation e.g. when covered. If the heater stops
operating whilst the flame effect continues normally this indicates that the cut out is
in operation. If this occurs disconnect the power supply at the plug socket-outlet and
ensure that any obstructions to the fan heater outlet or fan blades etc. are removed.
The heater will automatically reset when cool enough. The thermal cut out WILL
NOT RESET unless the obstruction is removed and the appliance cools. If the
heater is still not operating after 10 minutes disconnect the appliance and seek
expert advice.
If the supply cord is damaged it must be replaced by the manufacturer, its service
agent or a similarly qualified person in order to avoid a hazard. The cable used
MUST be capable of handling 2.5kW of power at 240V and MUST contain an earth
wire.
To completely shut this appliance off turn all the controls to OFF and remove the plug
from the socket-outlet.
Use the heater in a well-ventilated area.